So I've spent quite a few hours with Spark at this point.
However, I'm still confused by "face" creation.
The guide included in Launchpad has this to say about faces: "Left-click and drag to create an edge. Connecting multiple edges in a loop creates a face."
However, in practice this doesn't work unless I'm drawing a face on the same plane as the initial surface I initially created.
Am I missing something?
For example, if I have a clean slate and draw my first rectangle, it will fill in with a face. If I draw a rectangle connected to that initial rectangle, it will fill in with a face. Next, I extrude to create a room. Great. Whatever. Now when I attempt to draw another rectangle not connected to the initial plane, it does not fill in with a face.
Can someone advise me on this?
However, I'm still confused by "face" creation.
The guide included in Launchpad has this to say about faces: "Left-click and drag to create an edge. Connecting multiple edges in a loop creates a face."
However, in practice this doesn't work unless I'm drawing a face on the same plane as the initial surface I initially created.
Am I missing something?
For example, if I have a clean slate and draw my first rectangle, it will fill in with a face. If I draw a rectangle connected to that initial rectangle, it will fill in with a face. Next, I extrude to create a room. Great. Whatever. Now when I attempt to draw another rectangle not connected to the initial plane, it does not fill in with a face.
Can someone advise me on this?